| Tower Model |
LUSO36EU
|
LUSO36XX |
LUSO36MG |
| Maximum Height |
118ft. / 36m |
| Minimum Height |
41ft. / 12.5m |
| Wind Load Capacity |
75sq.ft. 5sq.m |
108sq.ft.10sq.m |
108sq.ft. 17sq.m |
Full extension wind speed : 57mph (92km/h) (25m/sec)
Bottom position wind speed : 157mph (253km/h) (70m/sec) |
| Maximum Loaded Weight |
330lbs / 150kg standard
|
660lbs / 300kg standard |
1320lbs / 600kg standard |
| Option max to 880lbs /400kg |
Option max to 1320lbs /600kg |
Option max to 2200lbs /1000kg |
|
50MHP : 75sq.ft. at full extension ( 22 m/seconds : 7㎡ at full extension) |
| Structure |
Triangular truss
Hot dip galvanizing |
| Width of bottom Section |
47inch / 1176mm |
| Length of a Section /Number of Sections |
36ft. / 11m , 4 Sections |
| Mast Bearing Stand |
Mast bearing stand on a top of tower |
| Rotator Installation Stand |
9ft. / 2610mm below the top of tower |
| Intermediate Mast BearingStand |
6ft. / 1760 mm below the top of tower |
| Control Method |
Full automatic (with Indoor remote controller, without cable)
Inverter control
With soft start/soft stop function |
| Rise up and rise down Speed |
Approximately 50 seconds |
| Winch |
Winch designed for LUSO120 exclusively
Worm reduction gear and chain drive
Drum with grooves for wires
Hot dip galvanizing then High temperature ( 392°F / 200℃ ) powder coating. |
| Electric Power for Winch |
Single phase AC 220 V , or your order specified |
|
| Motor Ratings Output |
4HP / 3 kw |
4HP / 3 kw |
5.4HP / 4 kw |
| Motor Control |
Inverter control |
| Counter Balancer |
Using two units of balance weights
Elevator system
Hot dip galvanizing then High temperature ( 392°F / 200℃ ) powder coating. |
| Guide Roller |
Guide Roller designed for LUSO Big series exclusively
Nitriding hardening
Two or more bearings are used per guide roller. |
| Pulley |
Pulley designed for LUSO Big series exclusively
Nitriding hardening
Two or more bearings are used per pulley. |
| Wire |
Many flexible steel wires for each side of the tower unit
The safety ratio of a wire far exceeds the elevator standard for man.
|
| Method for Detecting Top and Bottom Position |
Rotary limit switch designed for LUSO Big series exclusively |
| Total Weight |
12430lbs / 5650kg～ |
17160lb / 7800kg～ |
26400lb / 12000kg～ |
| Weight of Base Unit |
550lbs / 250kg |
| Length of Basic Unit |
7′7″ / 2000mm |
| Safety Fence |
It is an important security mechanism for preventing people contacting a machine operation section.
Three-sided fence |
| Shock Absorber |
It is an important security mechanism.
Three pieces for tower unit, Two pieces for balancer |
| Foundation |
See below |
