| Tower Model |
LUSO22EU  Self Supporting Crank-up Tower |
| Maximum Height |
72ft. / 22ｍ |
| Minimum Height |
|
| Wind load Capacity |
53.8sq.ft / 5㎡
Full extension wind speed : 57mph (92km/h) (25m/sec)
Bottom position wind speed : 157mph (253km/h) (70m/sec) |
| Maximum Loaded Weight |
330lbs / 150kg standard
Option Max to 660lbs / 300kg |
| Structure |
Triangular truss
Hot dip galvanizing |
| Width of bottom Section |
|
| Length of a Section /Number of Sections |
30ft. / 9m , 3 Sections |
| Mast Bearing Stand |
Mast bearing stand on a top of tower |
| Rotator Installation Stand |
9ft. / 2794mm below the top of tower |
| Intermediate Mast Bearing Stand |
6ft. / 1760mm below the top of tower |
| Control Method |
Full automatic (with Indoor remote controller, without cable)
Inverter control
With soft start/soft stop function |
| Rise up and rise down Speed |
Approximately 35 seconds |
| Winch |
Winch designed for LUSO22EU exclusively
Worm reduction gear and chain drive
Drum with grooves for wires
Hot dip galvanizing then High temperature ( 392°F / 200℃ ) powder coating. |
| Electric Power for Winch |
Single phase AC 220 V , or your order specified |
| Motor Ratings Output |
2HP / 1.5 kw |
| Motor Control |
Inverter control |
| Counter Balancer |
Using two units of balance weights
Elevator system
Hot dip galvanizing then High temperature ( 392°F / 200℃ ) powder coating. |
| Guide Roller |
Guide Roller designed for LUSO Big series exclusively
Nitriding hardening
Two or more bearings are used per guide roller. |
| Pulley |
Pulley designed for LUSO Big series exclusively
Nitriding hardening
Two or more bearings are used per pulley. |
| Wire |
Many flexible steel wires for each side of the tower unit
The safety ratio of a wire far exceeds the elevator standard for man. |
| Method for Detecting Top and Bottom Position |
Rotary limit switch designed for LUSO Big series exclusively |
| Total Weight |
5060lbs / 2300kg |
| Weight of Base Unit |
407lbs / 185kg |
| Length of Basic Unit |
6′7″ / 2000mm |
| Safety Fence |
It is an important security mechanism for preventing people contacting
a machine operation section.
Three-sided fence |
| Shock Absorber |
It is an important security mechanism.
Three pieces for tower unit, Two pieces for balancer |
| Foundation |
See below |
